Shaft Protection Sleeves & shaft protection bushings

Here you will find all of our shaft sleeves and shaft protection sleeves. We have unused as well as slightly used ones which are all available immediately.
for Voith VSi10 VSi11 and VSi12
Price on request
 
for Voith 2E deflaker
Price on request
 
for Lamort CH7
Price on request
 
for Escher Wyss FS2B
Price on request
 
for Escher Wyss FS1B & F1T
Price on request
 
Shaft Protection Sleeve
Price on request
 
shaft protection sleeve for deflaker E1 / E1K
Price on request
 
shaft protection sleeve
D = 49,90mm
d = 40,10mm
L = 140mm
out of brass
Price on request
 
shaft protection sleeve
D = 75mm
d unten = 61,10mm (with step inside)
d oben = 60,10mm
Länge = 115,15mm
Price on request
 
shaft protection sleeve Finckh H4 / H04
Price on request
 
shaft protection sleeve
D= 146,95
d= 128,15
L=244,5
Price on request
 
Show 1 to 12 (from a total of 12 products)

What are shaft protection sleeves for?

Shaft protection sleeves, or shaft protection bushings, are essential when using gland packing. The correct shaft diameter is only achieved through the use of shaft sleeves to ensure optimum tightness of the packing cord. Shaft protection bushings usually only adhere to the shaft at both ends, in order to better absorb the heat generated by friction between the packing cord and the ceramic coating. A so-called sealing water ring or lantern ring is used to further reduce the heat development here and to optimize the tightness again. In connection with the right amount and the right pressure of the sealing water and also the right packing pressure, the life of a shaft protection bush can be extended.